Monthly Archives: December 2011

Unfair electronics device tray done

Posted on by
Reply

Welded Fab Boss

The device tray is fully mounted, taking 9 FabBosses — 2 on each side and one in the middle. Only the one in the middle took any real careful measuring — and that was because I couldn’t get my MIG gun all the way underneath the tray. All the other FabBosses were bolted to the tray, trimmed to fit, and tack-welded into place. Continue reading →

Fabricating with FabBosses

Posted on by
Reply

2 Fab Bosses connected by a 1/4-20 stud

We sell our FabBosses in 1.25″ lengths, so they can be easily trimmed to fit. However, it might not immediately obvious how to precisely trim them since they are too short to put in a vise and cut. Continue reading →