Fuel and Differential Vent Install

Fuel and differential Vent sit nicely on top of the DSE Quadralink crossmember.

Modern muscle cars like the new Camaro have performance and drivability that could scarcely be imagined in 1969, but as technology has found its way into the aftermarket our older muscle cars are accelerating, braking, and cornering so well that fuel slosh, spillage, starvation, and odor have become a bigger problem than ever. A common problem is that under acceleration fuel will leak from the vented gas cap found on many older cars. Switching to a sealed cap eliminates the leak but now a properly designed vent system is needed.

Fuel tank venting is a deceptively complex problem and when improperly executed can result in spillage, fuel pump overheating, tank deformation, “burping” during fill ups, and strong fuel odors. Many resort to running a half tank of fuel and hoping for the best. To ensure we have a steady supply of fuel at all times we equipped our Camaro project with a Rick’s Tank and Vaporworx fuel pump system. Rick’s Tank and the Vaporworx system do not address tank venting, and both Rick’s and Vaporworx recommend our Fuel and Differential vent for this. We’ll be running our vents side by side — one for the DSE built 9 inch and the other to the Rick’s Tank

We’ve already upgraded the rear suspension to a DSE Quadralink, and the beefy crossmember that’s part of the kit is the ideal place to mount our vents since they need a 2.5″ hole in a flat and level space. All plumbing runs underneath the car, and the location needs to be chosen so that any collected liquid in the vent can run back to the tank or differential via gravity.

The gray nylon gasket resides in a precisely machined groove to keep it from being over-compressed, the white washer prevents scratching when tightening the main nut, the gold bit is a 40 micron sintered bronze filter, and the set screw keeps everything in place after installation.

Continue reading